Bauknecht GSU 158111 A++ Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Lave-vaisselle Bauknecht GSU 158111 A++. Bauknecht GSU 158111 A++ Instruction for Use Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
EN -1-
Chart
(see at right for options description)
PROGRAMS SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary
depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration
system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
*Power consumption in Left-on mode: 1.50 W / Off-mode: 0.50 W
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor 40-70°C
Delay
Hygiene
1/2 Load
Recommended program for routine
washes, with dried-on food.
X 7-15 1.00-1.70 70-172 Full
P2
Pre-Wash cold
Delay Crockery to be washed later. 4.0 0.01 14-16 NO
P3
Express 45°C
Delay
Lightly soiled crockery, with no dried-
on food.
X 11.0 0.85 30-50 NO
P4
Eco
2)
50°C
Delay
Hygiene
1/2 Load
Normally soiled crockery.
Standard program, the most efficient
in terms of its combined energy and
water consumption.
X 10.0 0.922 240 Full
P5
Normal 60°C
Delay
Hygiene
1/2 Load
Normally to heavily soiled crockery. X 11.0 1.30 80-95 Full
P6
Steam
Delay
Hygiene
Program including steam action
dedicated for heavily soiled crocery,
pots and pans. Soaking or hand
pretreatment is no longer needed.
X 14.5 1.75 180-190 Full
400010819063
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
1/2 LOAD BUTTON
Half load cycle can be used for
the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program.
The ˝Half Load˛ option can be
used with the programs
indicated in the table of
programs.
TABLET SETTING
This setting allows to
optimize the cycle
performances according the
type of detergent used.
Push the Tablet button for
3 seconds (until the indicator
lights up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder detergent
or gel detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program –
delay indicator turns on.
Adjustable from 1 to
24 hours. With each press
of the button, the delay
increases by one hour and
after "h 24" returns to
"h 00”. When this option
is selected the delay
indicator turns on. Then
press the START button.
The dishwasher will start
after the set time.
HYGIENE
This function activates an antibacterial rinse at the end of the wash
cycle, guaranteeing a further reduction of bacteria. Press the button
to activate or deactivate the function.
This function can be used with the programs indicated in the table of
programs. The dishwasher door must be kept shut for the entire
duration of the program in order to guarantee reduction of bacteria.
If the door is opened the indicator lamp starts flashing.
WASH TIME DISPLAY
Indicated the cycle
duration and the
remaining time (h:min).
With “Delayed start”
selected it indicates the
time remaining until
program start (h.00) -
below 1h (0:min).
If “Fx Ey” messages
appears on the display,
see page 6 - chapter
“What to do if...”.
Quick reference guide
Bauknecht is a registered trademark
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 400010819063

EN -1- Chart(see at right for options description)PROGRAMS SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on th

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksLOWER RACK - depending on the modelD - OPEN4A - Adjustable flaps (2 or 4): in horizontal position for cups / long utensils

Page 5 - Maintenance and care

EN -5-6512Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...have deposits: regeneration salt residue - Water too hard. - In areas

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A

Commentaires sur ces manuels

Pas de commentaire